Broan SP140 Instalační příručka stáhnout pdf (Strana 3)

INSTALL FRESH AIR INLETS

1. Add framing to ceiling joists as shown.

2. Set ventilator in place and screw it to framing with screws

provided. Ventilator may also be hung from ceiling joists

or rafters with hanging straps (available separately).

CEILING

JOISTS

2 X 4

FRAMING

CEILING

JOISTS

2 X 4

FRAMING

CONNECT DUCTWORK

6" ROUND

INSULATED

FLEXIBLE

DUCT

FROM

DIFFUSER

1. Run 6" insulated, flexible ductwork from ventilator inlet

to diffuser location(s) and from ventilator outlet to roof or

wall cap. Outlet side is marked with a label.

2. To minimize condensation inside of ductwork in the at-

tic, cover ductwork with additional insulation. Also, avoid

forming condensation traps in the ductwork runs.

3. Seal ductwork to ventilator and roof or wall cap with duct

tape or clamp (available separately)

WIRE THE VENTILATOR

TO ROOF OR

WALL CAP

DUCT

TAPE OR CLAMP

WARNING: DISCONNECT POWER AT SERVICE

ENTRANCE AND LOCK OUT SERVICE PANEL

TO PREVENT POWER FROM BEING SWITCHED

ON ACCIDENTALLY.

Use an ON/OFF switch to control the in-line ventilator.

Accessory timers and humidity controls are also available.

1. Remove the wiring adapter plate.

2. Attach power cable to wiring adapter plate using U.L./

CSA approved connector.

3. Connect black to black, white to white, and green or bare

wire to green ground screw.

4. Replace wiring adapter plate. Make sure tab on housing

slides through slot in plate.

ON/OFF

SWITCH

120 VAC

LINE IN

WIRING ADAPTER

PLATE

BLACK

GROUND

(Green or

Bare Wires)

GROUND

WIRE

WHITE

1. Mount all fresh air inlets in chosen locations during

rough-in construction. Follow directions packed with

inlets.

MOUNT THE VENTILATOR

OUTLET

SIDE

BLACK

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Broan SP140 Instalační příručka Strana 3

Komentáře k této Příručce

Související produkty a manuály pro ne Broan SP140